Description
Built-in Amplifier – Pulse Width Modulated design simplifies power supplies. It controls the output voltage and current precisely by removing the output current sensing loss & eliminating all secondary feedback circuitry. It’s efficient & reliable
KIT – 17’/8G red power cable, 40 amp fuse holder, 3’/8G ground cable, 16’/18G blue remote cable, 16’ RCA interconnect, 4″ wire ties, plastic grommets, #10 gold-plated ring terminals, butt splice wire connectors, tap screw, rubber terminal boot
Variable Low-Pass Filter – A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
High Level Inputs – Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the US10K to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
Low-Level Inputs – Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the US10K with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers
Variable Bass Boost – Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it
Phase Control – Phase control lets you adjust the speaker phase with the amplifier if your speakers or subwoofer are hooked up “out of phase”
Sound Storm Laboratories US10K 10 Inch Powered Under Seat Car Subwoofer – 1000 Watts Max, Dual 4 Ohm Voice Coil, 8 Gauge Amp Installation Kit
Reviews
There are no reviews yet.